Remote Control — Installation Manual

The Made for Arcade universal remote control installs in just 3 steps. It connects to the back of your coin comparator or coin acceptor and works alongside it. Once installed you can still use coins, or press the remote button to simulate a coin being inserted.

STEP 1

Unplug the coin comparator

Remove the 4-prong plug (usually with 3 wires) from the back of the coin comparator.

Step 1 — remove 4-prong plug from coin comparator

STEP 2

Connect the remote

Connect the female connector from the remote control to the male connector from the machine — the plug you just removed in Step 1.

Step 2 — connect remote female connector to machine

STEP 3

Power the remote & test

Connect the male connector from the remote to the female connector in the coin comparator.

Yellow wire → +12 volts
Red wire → GND / Ground
See the markings on the side of the coin comparator.

Turn on the machine and set it to PAID PLAY (coins or tokens). Press “A” on the remote → a credit should be added.

Coin comparator wiring markings: +12V and Ground

MODE SELECTION

Setting the correct mode

Open the box cover. It may be sealed with hot-glue — carefully pry it open with a screwdriver, or soften the glue with warm air (hair dryer).

Inside is a small white programming button (red arrow). With the machine on and the board plugged in, press “A” on the remote — a red or blue light briefly flashes. Use the white button to switch modes:

1. Momentary — USE THIS MODE ONLY. The light stays on only while “A” is held.

2. Toggle — DO NOT USE. “A” turns the light on, pressing again turns it off.

Bad signal? Try aiming the antenna (yellow arrow) for better reception.

Mode selection — programming button and antenna on the controller board

remote-control-installation

universal remote credit control.

Remote Control — Installation Manual

Unplug the coin comparator

Connect the remote

Power the remote & test

Setting the correct mode